Once released gently pull down on the wiring connector and remove it from the blend door actuator.
													
																	2004 chevrolet silverado changing the drivers side blend door actuator. 
									
	
		
	
																	I watched you video on replacing the blend door actuator. 
																	These clips can be brittle and break so be gentle. 
																	Remove the 7mm screw from the driver s side of the cross over bracket. 
																	I successfully removed the old and installed the new. 
															
													
									
	
		
	
																	Begin by using a small screwdriver to release the wiring safety clip on the harness for the actuator. 
																	Remove the 7 mm screws on the driver s side bracket. 
																	Replacing the driver side blend door actuator acdelco 1572972 and reseting the blend doors for the front a c system. 
																	It seems like the actuator is being told to turn the shaft to heat. 
															
													
									
	
		
	
																	My a c was stuck on just hot but this. 
																	Now the u shaped bracket on the passenger side can be removed. 
																	It was still blowing hot out of the driver s side. 
																	To see which blend door is t. 
															
													
									
	
		
	
																	Inspect the connector for rust or corrosion and clean as needed.